Fig. 454: Measuring Inner Gear-to-Crescent
Courtesy of CHRYSLER LLC
7. Measure clearance between inner gear (4) and crescent (3). Clearance should be 0.093 - 0.385 mm
(0.0036 - 0.0151 in.).
8. Position an appropriate piece of Plastigage across both pump gears.
9. Align the Plastigage to a flat area on the reaction shaft support housing.
10. Install the reaction shaft to the pump housing. Tighten the bolts to 27 N.m (20 ft. lbs.).
11. Remove bolts and carefully separate the housings. Measure the Plastigage following the instructions
supplied.
12. Clearance between both gear end faces and the reaction shaft support should be 0.020 - 0.046 mm (0.0008
- 0.0018 in.).
ASSEMBLY
ASSEMBLY
1 - FEELER GAUGE
2 - OUTER GEAR
3 - CRESCENT
4 - INNER GEAR
2009 Chrysler Town & Country LX
2009 AUTOMATIC TRANSMISSION 62TE - Service Information - Grand Caravan, Town & Country
steve
Monday, May 23, 2011 1:26:11 PM Page 279 © 2006 Mitchell Repair Information Company, LLC.
To Next Page
Loading...
