Danfoss VLT AutomationDrive FC 360

0.6
0.6
f
g
= 10 Hz
e75za293.11
Feedback
Disturbed feedback signal
t (Sec.)
t (Sec.)
Filtered feedback signal
Lowpass filter
Feedback
Figure 36: Feedback Signal
 NOTICE
Severe filtering can be detrimental to dynamic performance.
7-07 Speed PID Feedback Gear Ratio
Default value: 1.0000 Parameter type: Range (0.0001–32.0000)
Setup: All setups Conversion index: -4
Data type: Uint32 Change during operation: False
160 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360