Danfoss VLT AutomationDrive FC 360

To Next Page

To Previous Page

Select the trigger for the setup selection.

Option Name Description

[0] Digital input A digital input triggers the setup

selection.

[1] Bus A serial communication port or the

fieldbus triggers the setup selection.

[2] Logic AND The fieldbus/serial communication port

and a digital input trigger the setup

selection.

[3] Logic OR The fieldbus/serial communication port or

a digital input triggers the setup selection.

8-56 Preset Reference Select

Default value: [3] Logic OR Parameter type: Option

Setup: All setups Conversion index: –

Data type: Uint8 Change during operation: True

Select the trigger for the preset reference selection.

Option Name Description

[0] Digital input A digital input triggers the preset

reference selection.

[1] Bus A serial communication port or the

fieldbus triggers the preset reference

selection.

[2] Logic AND The fieldbus/serial communication port

and a digital input trigger the preset

reference selection.

[3] Logic OR The fieldbus/serial communication port

or a digital input triggers the preset

reference selection.

8-57 PROFIdrive OFF2 Select

Default value: [3] Logic OR Parameter type: Option

Setup: All setups Conversion index: –

Data type: Uint8 Change during operation: True

Select control of the drive OFF2 selection via the terminals (digital input) and/or via the fieldbus. This parameter is active only when

parameter 8-01 Control Site is set to [0] Digital and ctrl. word and parameter 8-10 Control Word Profile is set to [1] PROFIdrive profile.

Programming Guide | VLT® AutomationDrive FC 360

Other manuals for Danfoss VLT AutomationDrive FC 360