Danfoss VLT AutomationDrive FC 360

To Next Page

To Previous Page

Programming Guide | VLT® AutomationDrive FC 360

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: True

Manufacturer specific system ID.

9-22 Telegram Selection

Default value: [100] None Parameter type: Option

Setup: 1 setup Conversion index: –

Data type: Uint8 Change during operation: True

Select a standard PROFIDRIVE telegram configuration for the drive as an alternative to the freely configurable telegrams in parameter

9-15 PCD Write Configuration and parameter 9-16 PCD Read Configuration.

Option Name

[1] Standard telegram 1

[100] None

[101] PPO 1

[102] PPO 2

[103] PPO 3

[104] PPO 4

[105] PPO 5

[106] PPO 6

[107] PPO 7

[108] PPO 8

[200] Custom telegram 1

9-23 Parameters for Signals

Default value: [0] None Parameter type: Option, Array [1000]

Setup: All setups Conversion index: –

Data type: Uint16 Change during operation: True

This parameter contains a list of signals available for selection in parameter 9-15 PCD Write Configuration and parameter 9-16 PCD Read

Configuration.

Option Name

[0] None

[302] Minimum Reference

[303] Maximum Reference

Other manuals for Danfoss VLT AutomationDrive FC 360