Danfoss VLT AutomationDrive FC 360

Programming Guide | VLT® AutomationDrive FC 360
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: True
Provide information about the DO (drive object). This parameter is for PROFINET only.
9-80 Defined Parameters (1)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: False
Show a list of all the defined drive parameters.
9-81 Defined Parameters (2)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: False
Show a list of all the defined drive parameters.
9-82 Defined Parameters (3)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: False
Show a list of all the defined drive parameters.
9-83 Defined Parameters (4)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: False
Show a list of all the defined drive parameters.
9-84 Defined Parameters (5)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Setup: All setups Conversion index: 0
Data type: Uint16 Change during operation: False
Show a list of all the defined drive parameters.
9-85 Defined Parameters (6)
Default value: 0 Parameter type: Range (0–9999), Array [116]
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 201