Danfoss VLT AutomationDrive FC 360

Programming Guide | VLT® AutomationDrive FC 360
Principles and actions of changing the value of continuous parameters
e30bc446.10
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
1
2
3
4
5
6
7
10
11
12
OK
OK
Back
8
Back
Setup 1
2 x
+
OK
9
OK
Figure 12: Main Menu Interactions - Continuous Parameters
Table 7: Changing Values in Continuous Parameters
1 [OK]: The first parameter in the group is shown.
2 Press the Down key repeatedly to move down to the parameter.
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | 25