Danfoss VLT AutomationDrive FC 360 Programming Guide

Table 7: Changing Values in Continuous Parameters (continued)
3 Press [OK] to start editing.
4 The Right key: First digit flashing (can be edited).
5 The Right key: Second digit flashing (can be edited).
6 The Right key: Third digit flashing (can be edited).
7 Decreases the parameter value, the decimal point changes automatically.
8 The Up key: Increases the parameter value.
9 [Back]: Cancel changes, return to 2.
[OK]: Accept changes, return to 2.
10 The Up/Down key: Select parameter within the group.
11 [Back]: Removes the value and shows the parameter group.
12 The Up/Down key: Select group.
Principles and actions of changing the value of enumerated parameters
For enumerated parameters, the interaction is similar, but the parameter value is shown in brackets because of the LCP 21 digits
limitation (4 large digits), and the enum can be greater than 99. When the enum value is greater than 99, the LCP 21 can only show the
first part of the bracket.
e30bc447.11
Setup 1
Setup 1
Setup 1
1
2
3
4
5
6
OK
OK
Back
7
OK
Back
Figure 13: Main Menu Interactions - Enumerated Parameters
Table 8: Changing Values in Enumerated Parameters
1 [OK]: The first parameter in the group is shown.
2 Press [OK] to start editing.
3 The Up/Down key: Change parameter value (flashing).
4 Press [Back] to cancel changes or [OK] to accept changes (return to screen 2).
26 | Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507
Programming Guide | VLT® AutomationDrive FC 360

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English