Danfoss VLT AutomationDrive FC 360 Programming Guide

Programming Guide | VLT® AutomationDrive FC 360
4.4.6 3-7* Ramp 4 95
4.4.7 3-8* Other Ramps 96
4.4.8 3-9* Digital Pot.Meter 97
4.5 Parameter Group 4-** Limits/Warnings 99
4.5.1 4-1* Motor Limits 99
4.5.2 4-2* Limit Factors 101
4.5.3 4-3* Motor Fb Monitor 103
4.5.4 4-4* Adj. Warnings 2 104
4.5.5 4-5* Adj. Warnings 106
4.5.6 4-6* Speed Bypass 108
4.5.7 4-8* Power Limit 108
4.5.8 4-9* Directional Limits 109
4.6 Parameter Group 5-** Digital In/Out 110
4.6.1 5-0* Digital I/O mode 110
4.6.2 5-1* Digital Inputs 111
4.6.3 5-3* Digital Outputs 118
4.6.4 5-4* Relays 130
4.6.5 5-5* Pulse Input 136
4.6.6 5-6* Pulse Output 138
4.6.7 5-7* 24V Encoder Input 141
4.6.8 5-9* Bus Controlled 142
4.7 Parameter Group 6-** Analog In/Out 144
4.7.1 Introduction 144
4.7.2 6-0* Analog I/O Mode 144
4.7.3 6-1* Analog Input 53 145
4.7.4 6-2* Analog Input 54 147
4.7.5 6-7* Analog/Digital Output 45 148
4.7.6 6-9* Analog/Digital Output 42 155
4.8 Parameter Group 7-** Controllers 157
4.8.1 7-0* Speed PID Ctrl. 157
4.8.2 7-1* Torque PID Ctrl. 162
4.8.3 7-2* Process and Speed Ctrl. 163
4.8.4 7-3* Process PID Ctrl. 164
4.8.5 7-4* Adv. Process PID I 166
4.8.6 7-5* Adv. Process PID II 169
4.8.7 7-6* Feedback Conversion 170
Danfoss A/S © 2024.01 AU275649936274en-001401 / 130R0507 | iii

Danfoss VLT AutomationDrive FC 360 Specifications

General

Brand	Danfoss
Model	VLT AutomationDrive FC 360
Category	DC Drives
Language	English