Name: Danfoss VLT AutomationDrive FC 360
Brand: Danfoss
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Programming Guide | VLT® AutomationDrive FC 360

1-22 Motor Voltage

Default value: Size related Parameter type: Range (50–1000 V)

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: False

Enter the nominal motor voltage according to the motor nameplate data. The default value corresponds to the nominal rated output of

the unit.

1-23 Motor Frequency

Default value: Size related Parameter type: Range (5–500 Hz)

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: False

Select the motor frequency value from the motor nameplate. For 87 Hz operation with 230/440 V motors, set the value according to the

nameplate data for 230 V/50 Hz. Adapt parameter 4-14 Motor Speed High Limit [Hz] and parameter 3-03 Maximum Reference to the 87

Hz application.

1-24 Motor Current

Default value: Size related Parameter type: Range (0.01–1000.00 A)

Setup: All setups Conversion index: -2

Data type: Uint32 Change during operation: False

Enter the nominal motor current value from the motor nameplate data. This data is used for calculating motor torque, motor thermal

protection, and so on.

1-25 Motor Nominal Speed

Default value: Size related Parameter type: Range (50–60000 RPM)

Setup: All setups Conversion index: 0

Data type: Uint16 Change during operation: False

Enter the nominal motor speed value from the motor nameplate data. This data is used for calculating automatic motor compensations.

1-26 Motor Cont. Rated Torque

Default value: Size related Parameter type: Range (0.1–10000.0 Nm)

Setup: All setups Conversion index: -1

Data type: Uint32 Change during operation: False

Enter the value from the motor nameplate data. The default value corresponds to the nominal rated output. This parameter is available

when parameter 1-10 Motor Construction is set to [1] PM, non salient SPM or [3] PM, salient IPM, that is, the parameter is valid for PM,

non-salient SPM and PM, salient IPM motors only.

1-29 Automatic Motor Adaption (AMA)

Default value: [0] Off Parameter type: Option

Danfoss VLT AutomationDrive FC 360 Programming Guide

Other manuals for Danfoss VLT AutomationDrive FC 360