Dionex As - Page 118

AS Autosampler Operator’s Manual
106 Doc. 065051-03 1/08
• [237] Memory is full. Cannot save additional method or schedule.
The current method or schedule occupies all available memory.
Possible Causes: Too many complex methods or schedules have
been saved.
Actions: To free memory for future use, delete a method or
schedule that is no longer used.
• [250] DSP does not acknowledge.
The DSP (digital signal processor) did not respond to a command
from the CPU.
Possible Causes: Communication problem between the DSP and
the CPU.
Actions:
• Turn the power off and then back on.
• If the error message appears again, contact Dionex.
• [331] Method does not exist.
The schedule contains a method that does not exist.
Possible Causes: Incorrect method number entered into the
schedule.
Actions:
• Enter the method number of an existing method in the schedule.
• Create a new method and save it to the method number indicated
in the schedule.