Dionex As - Page 242

AS Autosampler Operator’s Manual
230 Doc. 065051-03 1/08
DILUTE...
The AS is performing a dilution as part of the
sample prep phase of the method.
REAGENT
PRIME...
The AS is priming the lines with reagent.
REAGENT
FLUSH...
The AS is flushing the inject port with reagent.
CONCENTRATE...
The AS is loading sample onto the concentrator
column.
WAITING
The AS is waiting for a command to continue
running a method. The command can be from the
front panel (pressing Hold/Run), from
Chromeleon or Chromeleon Xpress, or from a
TTL or relay input.
WAITING FOR
RUN TO FINISH
The AS has completed the overlapped sample
prep steps and is waiting for the timed events of
the previous method to be completed.
EXECUTING
SETUP AND INIT
STEP
The AS is executing the method setup conditions
and the
INIT step of the method’s timed events.
WAITING FOR
CYCLE TIME TO
EXPIRE
The AS is waiting for the cycle time to expire
before starting the method’s timed events.
WAITING FOR
TEMP TO
STABILIZE
The AS is waiting for the tray temperature to
stabilize before starting the method’s timed
events.
EXECUTING
TIMED EVENTS
The AS is executing the method’s timed events.
This status message is displayed until a load or
inject step is executed.
LOADING LOOP
Sample is being loaded into the loop during the
method’s timed events.
LOADING
CONCENTRATOR
Sample is being loaded onto the concentrator
during the method’s timed events.
INJECTING
Sample is being injected during the method’s
timed events.
ABORTING,
PLEASE WAIT
The AS is performing operations necessary to
abort the schedule.
Screen Field Description