Dionex As - Page 246

AS Autosampler Operator’s Manual
234 Doc. 065051-03 1/08
TRAY
(type)
The tray type in use.
NONE, 2 mL,
P10 mL
(10 mL
plastic),
WP.5mL,
WP 2mL (0.5 mL
or 2 mL well plate)
LOOP
The size of the loop in microliters. Note: If the
AS is equipped with two injection valves, two
loop sizes are shown. If the AS is in concentrate
mode,
CONCENTRATOR is displayed.
(Injection
Type)
The type of injection performed. This field is
updated when the initial conditions of the
method’s timed events are executed.
See Table C-1
TTL1
TTL2
RLY1
RLY2
Provides TTL and relay control of other devices.
In Direct Control, select 1 (on) or 0 (off). In
Schedule control, set the TTL and relay fields
from the
TIMED EVENTS screen for the method
being run. Appendix E
describes TTL and relay
control.
1 (on)
0 (off)
INJ VLV
Displays, and lets you set, the position of the
injection valve.
L (load)
I (inject)
INJ VLV 1
INJ VLV 2
(simultaneous
injection
mode only)
If the AS is equipped with two injection valves
(for simultaneous injections), these fields display,
and let you set, the position of each valve.
Injection valve #1 is the bottom valve and
injection valve #2 is the top valve. See
Section 3.6.9
for details about the simultaneous
injection option.
L (load)
I (inject)
Diverter
Displayed when the AS is equipped with a
diverter valve for sequential injections and
sequential or sequential concentrate is the
selected sampling mode.
A (system 1)
B (system 2)
Screen Field Description Values