Dionex As - Page 305

D • Front Panel Control
Doc. 065051-03 1/08 293
Setting the Tray Temperature
The TRAY TEMPERATURE parameter is available only when the sample
temperature control option is installed. Otherwise, this field displays “--”
and is not illuminated.
1. On the
METHOD SETUP screen, position the cursor in the TRAY
TEMPERATURE
field.
2. If the field displays “--”, tray temperature control is currently turned
off. Press
Select Δ or Select ∇ to turn on tray temperature control.
3. Press numeric buttons to enter the desired temperature setting.
4. Press
Enter.
Waiting for the Temperature to Stabilize
The WAIT FOR TEMP STABLE parameter delays the start of the method
until the temperature of the sample tray has reached the specified set
point(s).
1. Position the cursor in the
WAIT FOR TEMP STABLE field.
2. Press
Select Δ or Select ∇ to select either YES (wait) or NO (do not
wait).
3. Press
Enter.