Remote Viewing Interface
16
2. Select the menus that you wish to restore to factory defaults.
3. Click Save to restore system defaults for the selected items.
16.30 Configuring Event Settings
The Event Settings tab allows you to configure how the system behaves when a system
event occurs (e.g. hard drive error, video loss). This is useful if you want your DVR to notify
you if there is a potential system problem.
To configure the system event settings:
1. Click the Remote Setting tab, and click Advanced > Events.
2. Configure the following:
• Event Type: Configure the type of event that triggers the system to send an alert.
• Enable: Select Enable to activate the system to notify you if an event occurs.
• Buzzer: Select OFF to enable/disable the system buzzer or select the duration of
the system buzzer after an event occurs.
• Show Message: Select the checkbox to enable the system to display a warning
message when an event occurs.
• Send Email: Select the checkbox to enable email notifications. Email notification
must be enabled.
• Alarm Out: Enable or disable the alarm out panel.
• Latch Time: Configure the system latch time after an event occurs.
3. Click Save to save changes.
#LX400005; r. 1.0/13714/13883; en-US
97
To Next Page
Loading...
Need help?
General
