Setting up Your DVR for Remote Connectivity
15
15.2 Accessing your DVR within a local network (LAN)
You can connect to your DVR over the local area network (LAN). It is recommended to
confirm connectivity over a local network before setting up your DVR for Internet
connectivity.
Note
To complete the steps below, your computer must be on the same network as your DVR.
Note
Except where noted, the instructions below are the same for PC and Mac.
15.2.1 Step 1 of 3: Connect your DVR to the Local Area Network
1. Power off your DVR by turning the power switch to ●.
2. Connect an Ethernet cable (included) to the LAN port on the rear panel of the DVR.
Connect the other end of the Ethernet cable to a router or switch on your network.
3. Turn the power switch to I to power the DVR back on.
8–channel model shown
#LX400005; r. 1.0/13714/13883; en-US
69
To Next Page
Loading...
