Setting the Date and Time
10
To enable automatic DSTadjustments:
1. Click the DST Setup button.
2. Configure the following:
• Daylight Saving Time: Select Enable.
• Time Offset: Select the number of hours the system should move forward or back-
ward when DSToccurs.
• Daylight Saving Time Mode: Select Week or Date. This allows you to select
whether DST should begin and end at the beginning of the week or on a specific
date.
• Start Time, End Time: Enter when DSTstarts and ends.
3. Click Apply to save your settings.
10.2 Using a NTP Server to set your System Time
A NTP (Network Time Protocol) server syncs your system time with an online time server.
Note
A constant Internet connection is required to use the NTP feature.
#LX400005; r. 1.0/13714/13883; en-US
24
To Next Page
Loading...
Need help?
General
