Remote Viewing on Internet
Explorer
20
You can connect to your DVR using Internet Explorer 7 or higher on a PC.
Note
On PC, remote viewing is only compatible with Internet Explorer. Mozilla Firefox, Opera, and other brows-
ers are not supported. For Safari connection instructions, see 15 Setting up Your DVR for Remote Con-
nectivity, page 68.
Prerequisites:
• The HTTP Port (default: 80) and Client Port (default: 9000) must be port forwarded to
your router.
• You must create a DDNS account, and have the DDNS settings configured in your DVR.
For details, see 15.3 Accessing your DVR Remotely over the Internet, page 72.
• The DVR must have internet access.
To connect to your system on Internet Explorer:
1. Open Internet Explorer.
Note
If you are connecting using Internet Explorer 9, you must use the 32-bit version. From the Start
Menu, click Internet Explorer. Do not click Internet Explorer (64-bit).
Note
It is recommended to select Run as administrator when you open Internet Explorer to ensure full
functionality.
2. Enter the IP Address or DDNS address of the DVR in the address bar:
• IP Address: Enter http://, the IP address of the DVR, colon, and the HTTP port
number of the DVR (e.g. http://192.168.5.118:80) into the address bar. You must
include the HTTP port number of the DVR after the address. You can obtain the lo-
cal IP address from the DVR by pressing
on the front panel.
Example of a Local IP Address
http://192.168.0.101:80
• DDNS Address: The DDNS address must include http:// , the name of your DDNS
URL, followed by .myddns-flir.com, a colon, and then the HTTP port number of
your DVR.
Example of a DDNS address
http://tomsmith.myddns-flir.com:80
#LX400005; r. 1.0/13714/13883; en-US
132
To Next Page
Loading...
Need help?
General
