Using the Main Menu14
2. Configure the following:
• Channel: Select the channel you wish to configure.
• Enable: Select Enable or Disable to activate or deactivate motion recording.
• Area: Click the Setup button to configure the area of the screen that detects motion.
Click and drag the mouse cursor to configure motion detection areas. Motion detection is enabled in
red areas and disabled in transparent areas. Right-click to exit.
• Sensitivity: Select motion sensitivity. The greater the number, the greater the
sensitivity.
• Alarm Out: Select the checkbox to enable the system to trigger a device connected
to the alarm block.
• Latch Time: Enter the duration the alarm continues to trigger after the event ends.
• Show Message: Select the checkbox if you want the system to display a system
message when an alarm triggers.
• Buzzer: Select the duration the system will "beep" when motion is detected. Or se-
lect OFF to disable the "beep" during motion events.
• Send Email: Select the checkbox if you want the system to send email notifications
if an alarm triggers. Email notifications must be configured.
• Record Channel: Select the channel you wish the DVR to record during motion
recording.
• Full Screen: Select the Full Screen check box so that the system goes into full
screen mode when motion or an alarm trigger is detected.
• Post Recording: Enter the post recording duration (the time the system continues
to record after a motion event occurs).
3. Click Apply to save your settings.
14.5.2 Configuring Alarm Settings
The Alarm settings menu allows you to configure how the system behaves when an exter-
nal alarm device (not included) is triggered.
#LX400005; r. 1.0/13714/13883; en-US
58
To Next Page
Loading...
Need help?
General
