FLIR D3300 Series - Restoring to Factory Default Settings

Using the Main Menu14
6. Click Firmware Update.
7. Follow the on-screen instructions to update the firmware. Do not remove the USB
flash drive or power off the DVR during the firmware update. Wait for the system
to reboot.
14.8.2 Restoring to Factory Default Settings
Restoring to factory default settings reverts any setting changes you have made to their
original settings. This does not affect the recordings saved on the DVR. You can reset a
single menu, or all menus.
To load system defaults:
1. Right-click to open the Menu Bar and click the Main Menu button (
).
2. Click Advanced. Then click Load Default.
#LX400005; r. 1.0/13714/13883; en-US
63