Only applicable for removing intact HDD / SSD modules:
Ê Before removing a non-defective HDD / SSD module, put the drive into
"Offline" mode using your RAID configuration software.
7.4.2 Removing a 2.5-inch HDD / SSD / PCIe SSD
module
Ê Remove the HDD / SSD module to be replaced from the server as described
in section "Removing a 2.5-inch HDD / SSD / PCIe SSD module" on
page 113.
7.4.3 Installing a 2.5-inch HDD / SSD / PCIe SSD module
Ê Install the new HDD / SSD module into the empty drive bay as described in
section "Installing 2.5-inch HDD / SSD / PCIe SSD modules" on page 110
7.4.4 Concluding steps
Ê If applicable, "Performing a RAID array rebuild" on page 81
To Next Page
Loading...
Need help?
General