EasyManua.ls Logo

Fujitsu Primergy RX4770 M1 - Replacing the CMOS Battery

Fujitsu Primergy RX4770 M1
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
274 Upgrade and Maintenance Manual RX4770 M1
System board and components
14.2 Replacing the CMOS battery
Safety notes
V CAUTION!
The CMOS battery must be replaced with an identical battery or with
a battery type recommended by the manufacturer.
Keep lithium batteries away from children.
Do not throw batteries into the trash can. Lithium batteries must be
disposed of in accordance with local regulations concerning special
waste.
For further safety information, please refer to section "Environmental
protection" in the operating manual of your server.
14.2.1 Preliminary steps
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting power cords" on page 46
Ê "Getting access to the component" on page 48
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver; recommended: tooth pick

Table of Contents

Related product manuals