Installing the mid-brace
Figure 142: Installation of the the mid-brace
Ê Insert the mid-brace into its lateral guide channels until it stops.
I Install the mid-brace while holding the SAS cable by hand.
Ê Fasten the 3 screws (see arrows)
11.2.3 Concluding steps
Ê "Reassembling" on page 53
Ê "Connecting the server to the power source" on page 57
Ê "Updating or recovering the system board BIOS and iRMC" on page 67
Ê "Switching on the server" on page 58
Ê "Enabling SVOM boot watchdog functionality" on page 74
Ê "Resuming BitLocker functionality" on page 80
To Next Page
Loading...
