Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section "Removing the slot bracket" on
page 143.
9.3.3.3 Installing an expansion card
Ê If applicable, "Installing a slot bracket" on page 138.
Ê "Installing expansion cards" on page 142.
Ê If applicable, "Installing SFP+ transceiver modules" on page 192.
9.3.3.4 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "List of used
cables" on page 311.
9.3.3.5 Connecting a battery backup unit to the expansion card
Ê If applicable, connect an FBU to the expansion card as described in section
"Installing an FBU" on page 177.
9.3.3.6 Concluding steps
Ê "Reassembling" on page 53
Ê Reconnect all external cables to the replaced expansion card.
Ê "Connecting the server to the power source" on page 57
Ê "Switching on the server" on page 58
Ê "Enabling replaced components in the system BIOS" on page 75
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section "Looking up changed MAC / WWN addresses"
on page 82.
Ê "Updating RAID controller firmware" on page 70
Ê "Enabling SVOM boot watchdog functionality" on page 74
Ê "Resuming BitLocker functionality" on page 80
To Next Page
Loading...
