11.4.2 Upgrading or replacing a processor
I This description applies to the following procedures:
– Installing another processor
– Transfering a processor after replacing the system board (see section
"Replacing the system board" on page 298)
– In case of installing another processor remove the protective cover as
described in section "Installing a processor" on page 233.
– Remove the desired processor as described in section "Removing a
processor" on page 241.
– Install the new processor as described in section "Installing a processor" on
page 233.
11.4.3 Concluding steps
Ê "Installing processor heat sinks" on page 252
Ê "Installing the mid-brace" on page 239
Ê "Installing memory boards" on page 223
Ê "Installing expansion cards" on page 142
Ê "Reassembling" on page 53
Ê "Connecting the server to the power source" on page 57
I If Global Error LED is flashing with error message CPU has been
changed on display after the system is powered on, please follow the
procedure below.
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the LED stops flashing.
To Next Page
Loading...
Need help?
General