9.7.2.3 Concluding steps
Ê "Reassembling" on page 53
Ê "Connecting the server to the power source" on page 57
Ê "Switching on the server" on page 58
Ê "Enabling SVOM boot watchdog functionality" on page 74
Ê "Resuming BitLocker functionality" on page 80
9.7.3 Replacing PCIe SW cards
9.7.3.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 59
Ê "Disabling SVOM boot watchdog functionality" on page 60
Ê "Locating the defective server" on page 43
Ê "Shutting down the server" on page 46
Ê "Disconnecting power cords" on page 46
Ê Remove all external cables from the PCIe SW card to be replaced.
Ê "Getting access to the component" on page 48
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs as described in section "Onboard indicators and controls" on
page 321.
9.7.3.2 Removing a PCIe SW card
Ê "Removing PCIe SW cards" on page 173
Ê If the slot bracket on the defective PCIe SW card is to be reused, remove it from
the board as described in section "Removing the slot bracket" on page 143.
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
Need help?
General