For Windows Server 2008:
Ê Open BitLocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking Security, and then clicking BitLocker Drive
Encryption.
Ê Select the system volume, and click Turn On BitLocker.
For Windows Server 2008 R2 and above:
Ê Open BitLocker Drive Encryption by clicking the Start button, clicking
Control Panel, clicking System and Security, and then clicking BitLocker
Drive Encryption.
Ê Select the system volume, and click Resume Protection.
I For further information on how to resume BitLocker drive
encryption, please refer to the Microsoft TechNet library at
http://technet.microsoft.com/library/cc731549.aspx.
Fujitsu service partners will find additional information (also available
in Japanese) on the Fujitsu Extranet web pages.
5.2.14 Performing a RAID array rebuild
After replacing a hard disk drive that has been combined into a RAID array,
RAID rebuild will be performed completely unattended as a background
process.
Ê Ensure that the RAID array rebuild has started normally. Wait until the
progress bar has reached at least one percent.
Ê Inform the customer about the remaining rebuild time, based on the
displayed duration estimate.
Figure 10: Progress bar (RAID array rebuild)
To Next Page
Loading...
Need help?
General