Hamilton G5 - Page 590

Index-6 624074/07
Index
Noninvasive ventilation (NIV)
required conditions for use D-4
selecting a patient interface D-5
O
O
2
enrichment key, about 1-18
O
2
monitoring, enabling/disabling 4-17
Option key already in use user message
10-27
Option key invalid user message 10-27
Option unknown user message 10-27
Otis’ equation C-26
Oxygen + air supplies failed alarm
10-28
Oxygen alarms off user message 10-26
Oxygen cell
calibrated OK user message 10-26
calibration 4-14
calibration in progress user message
10-26
calibration needed alarm 10-26
defective alarm 10-26
installation 2-13
location of 1-26
misconnected user message 10-26
missing alarm 10-26
Oxygen monitored parameter
accuracy A-20
Oxygen supply failed 10-28
P
Parameters
monitored, list of 7-18
pulse oximeter-related F-17
Patient information, changing 5-5
Patient monitor, connecting to 2-32
Patient setup window, starting
ventilation 5-4
Patient system tight user message
10-29
Patient window 5-5
access to 1-22
changing patient information 5-5
Paux connector, location of 1-23
Perfusion index (PI)
alarms F-29
parameter F-18
Pneumatic diagram G-1
Pneumatic specifications A-3
Power
icons on screen, location of 1-22
specifications A-4, A-5
switch, location of 1-25
Powering on the ventilator 2-33
Pre-op checks
performing 4-3
with heliox, performing 4-6
Press Manual breath to resume user
message 10-29
Pressure monitored parameter accuracy
A-20
Pressure not released alarm 10-30
Pressure relief valve exhaust, location of
1-25
Pressure-controlled CMV mode. See
P-CMV
Pressure-controlled SIMV mode. See
P-SIMV
Print screen
failed, user message 10-30
key, about 1-18
P-SIMV mode, theory of operation B-9
Pulse oximeters 1-16
alarm settings F-27, F-29, F-30
alarms F-26
module, installing 2-12
Spot Check in Masimo Rainbow,
using F-23
testing 4-16
Pulse rate alarm F-27
Pulse rate parameter F-18
P/V tool maneuver option 9-1
setting ranges and resolutions A-19