Hioki 3166 - Page 224

202
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Output interval setting
Synta
x
INTEgrate:INTerval data1,data2
dat
a
data1 Hours 0 to 1000 (numerical data in NR1 format)
data2 Minutes 0 to 59 (numerical data in NR1 format)
Functio
n
Sets the output interval timer (the automatic output interval during
integration).
Erro
r
・An execution error results if an attempt is made to set a time outside of th
e
ranges indicated above.
・In the following circumstances, a device dependent error is generated:
If an attempt was made to execute this command while waiting for or
during integrated measurement.
In the event of a system error.
Exampl
e
Transmission
":INTE:INT 1,0"
Sets the output interval timer to 1 hour.
■ Output interval timer query
Synta
x
INTEgrate:INTerval?
Functio
n
Returns the output interval timer in (data1), (data2) in the form of NR1
numeric data .
Respons
e
synta
x
If headers are ON
If headers are OFF
":INTEGRATE:INTERVAL data1,data2"
"data1,data2"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":INTE:INT?"
":INTEGRATE:INTERVAL 1,0"
":INTE:INT?"
"1,0"
I
NTEgrate:INTerval
I
NTEgrate:INTerval?