Hioki 3166 - Page 256

234
────────────────────────────────────────────────────
11.4 Command Reference
────────────────────────────────────────────────────
■ Turns voltage auto rang setting
Synta
x
VOLTage:AUTO data
dat
a
ON, OFF (character data)
Functio
n
Turns voltage auto ranging ON or OFF.
Erro
r
･ In the following circumstances, a device dependent error is generated:
If this command is executed in the hold state.
If an attempt was made to execute this command while waiting for or
executing integrated measurement and demand measurement.
In the event of a system error.
･ If data is set to character data other than "ON" or "OFF", an execution
error is generated.
Exampl
e
Transmission
":VOLT:AUTO ON"
Voltage auto range setting is turned on.
■ Voltage auto rang setting query
Synta
x
VOLTage:AUTO?
Functio
n
Returns as "ON" or "OFF" (data) whether or not voltage auto ranging is
presently enabled.
Respons
e
synta
x
If headers are ON
If headers are OFF
":VOLTAGE:AUTO data"
"data"
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
":VOLT:AUTO?"
":VOLTAGE:AUTO ON"
":VOLT:AUTO?"
"ON"
V
OLTage:AUTO
V
OLTage:AUTO?