Hioki IM3533 - 11 Setting Operation Sounds (Beep Sounds)

4.5 Setting Application Settings
143
4
Chapter 4 LCR Function
You can set the operation sound and each of the beep sounds for judgment results.
4.5.11 Setting Operation Sounds (Beep Sounds)
Procedure
LCR Measurement Screen
1
LCR Application Settings
Beep Sound Settings
4
Press to close the setting screen.
3
Press .
2
LCR Application Settings
Beep sound setting for when key pressed
When a key is pressed, no beep sound is emitted.
When a key is pressed, a beep sound is emitted.
Beep tone settings
You can select from four beep tones
( , , , and ).
• When judgment performed with 1 comparator
When the comparator result is IN, a beep sound is
emitted.
When the comparator result is LO or HI, a beep
sound is emitted.
• When judgment performed with 2 comparators
When both of these comparator results are IN, a
beep sound is emitted.
When either one is LO or HI, a beep sound is
emitted.
Beep sound settings for when comparator judgment
When a comparator judgment is made, no beep
sound is emitted.
If an invalid key is pressed or an operation causes an error, an error tone will sound regard-
less of whether the beep tone is turned on or off.