Hioki IM3533 - Turning the Power on and off

2.7 Turning the Power On and Off
35
2
Chapter 2 Measurement Preparations
Connect the power cord and voltage and current measurement cables before turning the main power on.
2.7 Turning the Power On and Off
Power switch
Turning main power on
Turn the POWER switch on ( | ).
Lights green
To ensure that measurements fulfill the
degree of accuracy described in the
specifications, , allow at least 60 minutes
warm-up before executing zero adjust-
ment.
If the main power switch is tuned off while the instrument is in the standby state, it will start
up in the standby state the next time the main power switch is turned on.
Turning main power off
Turn the POWER switch off ( ).
Instrument settings are retained, even if the POWER switch is
turned off (backup function).
OFF
When the power supply is interrupted by a power failure or the like, the instrument recovers
in the measurement mode used before the power failure.