5.3 Application Settings
185
5
Chapter 5 ANALYZER Function (IM3533-01)
You can set the operation sound and each of the beep sounds for judgment results.
5.3.8 Setting Operation Sounds (Beep Sounds)
If an invalid key is pressed or an operation causes an error, an error tone will sound regard-
less of whether the beep tone is turned on or off.
Procedure
ANALYZER Application Settings
1
ANALYZER Measurement Screen
2
Press .
ANALYZER Application Settings
Beep Sound Settings
3
Beep tone settings
You can select from four beep tones ( ,
, , and ).
Beep sound setting for when key pressed
When a key is pressed, no beep sound is emitted.
When a key is pressed, a beep sound is emitted.
4
Press to close the setting screen.
To Next Page
Loading...
