Hioki IM3533 - 10 Setting the Point Delay

5.2 Setting Basic Settings of Measurement
168
For the point delay setting, set the delay time for each sweep point.
5.2.10 Setting the Point Delay
In sweep measurement, some measurement samples may require time for the measured
value to stabilize due to transient response. In this case, set a point delay time.
See "5.2.4 Setting the Trigger Delay" (p. 153)
Procedure
ANALYZER Measurement Screen ANALYZER Basic Settings
1
Press .
ANALYZER Basic Settings
2
Use or to enter the delay time.
3
Settable range: 0.0000 s to 10000 s
Point Delay Setting
When you want to cancel the point delay
function: Press .
The setting value is cleared to 0.
4
Press to close the setting screen.