Hioki IM3533 - Instrument and Printer Settings; Make Instrument Settings

13.2 Instrument and Printer Settings
333
13
Chapter 13 Printing
13.2 Instrument and Printer Settings
Make Instrument Settings
This operation is possible in any of the mode, mode and mode.
1
LCR Measurement Screen Interface Setting
Procedure
2
Printer Settings
Press and select the printing
method.
In ANALYZER mode (IM3533-01 only),
[TYPE] cannot be selected.
Only the screen can printed.
Manual Print
Outputs the measurement values
only when of the measure-
ment screen is pressed.
Auto Print
Outputs the measurement values af-
ter measurement finishes.
Prints the measurement results as
text.
Prints the screen.
BAUD RATE Communication speed with the
printer
HANDSHAKE Configuring flow control
3
Select and check each of the settings, and press to close the setting screen.
The printer's communication speed (baud rate) and flow control settings are the same as the RS-232C settings.
If the communication speed is changed, you may need to increase the print speed. It is also necessary to change the
printer's communication speed setting. When the communication speed is increased, the printer may be unable to keep
up, preventing data from being printed properly.
If this occurs, use hardware or software flow control. For more information, see the instruction manual that came with
the printer.