Hioki IM3533 - Setting Basic Settings of Measurement Conditions

6.2 Setting Basic Settings of Measurement Conditions
198
6.2 Setting Basic Settings of Measurement
Conditions
Basic settings apply to LCR mode, ANALYZER mode, and TRANSFORMER mode.
Procedure
TRANSFORMER Measurement Screen
1
TRANSFORMER Basic Settings
Sets the measurement frequency (p. 49).
Sets the measurement signal level (p. 51).
Sets the voltage and current limits (p. 55).
Sets the measurement range (p. 61).
Sets the measurement speed (p. 72).
Configures averaging (p. 73).
Sets the trigger delay (p. 75).
Configures the trigger synchronous
output function (p. 76).
Select the setting you wish to configure.
2
TRANSFORMER Basic Settings
3
Press to close the setting screen.