Hioki IM3533 - Setting the LCD to ON;OFF

7.5 Configuring CONTINUOUS Measurement Application Settings
214
You can turn the LCD ON/OFF.
Setting the LCD to OFF saves power because the LCD turns off if the panel is not touched for 10 seconds.
7.5.2 Setting the LCD to ON/OFF
Procedure
CONTINUOUS Measurement Application SettingsCONTINUOUS Measurement Screen
1
Press .
2
CONTINUOUS Measurement Application Settings
When you want to turn the backlight on
again:
If you touch the touch panel while the backlight is off,
the backlight will turn on again.
3
LCD setting
Turns OFF the LCD.
The LCD turns off after approximately 10 sec-
onds elapse since the touch panel was last
touched.
Sets the LCD to always on.
Select the LCD setting, and press to
close the setting screen.