Operating Precautions
8
Input modules (option)
Before replacing the input module
• To avoid electric shock accident, before removing or replacing an input module, confirm
that the instrument is turned off and that the power cord and connection cables are dis-
connected.
• The mounting screws must be firmly tightened or the input module may not perform to
specifications, or may even fail.
• Always turn both devices OFF when connecting and disconnecting an interface connec-
tor.
Otherwise, an electric shock accident may occur.
When not using an input module (option)
To avoid the danger of electric shock, never operate the instrument with an input module
removed. To use the instrument after removing an input module, be sure to attach the blank
panel.
Handling the LCR Application Disk
• Always hold the disc by the edges, so as not to make fingerprints on the disc or scratch
the printing.
• Never touch the recorded side of the disc. Do not place the disc directly on anything
hard.
• Do not wet the disc with volatile alcohol or water, as there is a possibility of the label print-
ing disappearing.
• To write on the disc label surface, use a spirit-based felt pen. Do not use a ball-point pen
or hard-tipped pen, because there is a danger of scratching the surface and corrupting
the data. Do not use adhesive labels.
• Do not expose the disc directly to the sun's rays, or keep it in conditions of high tempera-
ture or humidity, as there is a danger of warping, with consequent loss of data.
• To remove dirt, dust, or fingerprints from the disc, wipe with a dry cloth, or use a CD
cleaner. Always wipe from the inside to the outside, and do no wipe with circular move-
ments. Never use abrasives or solvent cleaners.
• Hioki shall not be held liable for any problems with a computer system that arises from
the use of this LCR Application Disk, or for any problem related to the purchase of a Hioki
product.
To Next Page
Loading...
