4.1 About LCR function
46
When a measurement value is outside the guaranteed accuracy range, “Reference Value”
is displayed in the error display area. When this happens, the cause is likely to be one of the
following. Check the guaranteed accuracy range in "14.2 Measurement Range and Accu-
racy" (p. 342) and change the measurement conditions or you should consider the mea-
sured values as values for reference.
• Perhaps the test signal level is too low, increase the test signal level.
• If the current measurement range (during HOLD setting) is not appropriate, set again in the AUTO
range, or change the range by manual.
To Next Page
Loading...
