tion
Speed
Set the transmission rate of the port:
• 10—10 Mbps.
• 100—100 Mbps.
• 1000—1000 Mbps.
• Auto—Autonegotiation.
• Auto 10—Autonegotiated to 10 Mbps.
• Auto 100—Autonegotiated to 100 Mbps.
• Auto 1000—Autonegotiated to 1000 Mbps.
• Auto 10 100—Autonegotiated to 10 or 100 Mbps.
• Auto 10 1000—Autonegotiated to 10 or 1000 Mbps.
• Auto 100 1000—Autonegotiated to 100 or 1000 Mbps.
• Auto 10 100 1000—Autonegotiated to 10, 100, or 1000 Mbps.
Duplex
Set the duplex mode of the port:
• Auto—Autonegotiation.
• Full—Full duplex.
• Half—Half duplex.
Link Type
Set the link type of the current port: hybrid or trunk. For more information, see
"Configuring VLANs."
IMPORTANT:
To change the link type of a port from trunk to hybrid, or vice versa, you must first set its link
type to access.
PVID
Set the default VLAN ID of the interface. For more information about setting the PVID, see
"Configuring VLANs."
IMPORTANT:
To make sure a link properly transmits packets, the trunk or hybrid ports at the two ends of
the link must have the same PVID.