If there is a failure at this point, the front panel will display an error.
3. Once the unit information is obtained, it is displayed on the front panel. Press OK to exit.
4. Once the process is completed, OK is displayed on the front panel.
EEROM Reset
The purpose of this diagnostic is to reset the EEROM values.
NOTE: Once the EEROM has been reset, the printer will act as if it is being started for the first time, except
that the Ink Supply Tubes have already been primed.
Perform an EEROM Reset as follows:
1. In the Service Tests submenu, scroll to EEROM Reset and press OK.
2. The front panel advises you that all user information/files will be removed. Press OK to reset the EEROM
or Cancel to exit.
3. While the EEROM is being reset, the front panel displays the following message.
ENWW Entering the Service Tests menu 97
To Next Page
Loading...