9. Remove the Carriage Flex Cable from the printer.
Encoder Strip and Encoder Sensor
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 213.
2. Remove the Left Cover
See Cover, Left on page 215.
3. Uncap the Carriage Assembly by manually pulling out the Printhead Maintenance Cartridge tray.
4. Lift the Primer and hold the Primer to its maximum position to avoid damaging it when you move the
Carriage Assembly in the next step.
282 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...