HP Designjet T7200 - SE 81:01; SE 85:03; SE 86:01; SE 86:11

●
Try to reprint the image using different selections in the driver.
●
Disable nesting and the queue.
●
If the problem persists, perform Hard Disk Recovery (see
Hard Disk recovery on page 110).
SE 81:01
Cause: Paper servo shutdown; possible paper jam
Solution: Try the following.
●
Open the Window and check for any visible obstacles restricting the movement of the Drive Roller. If
there is a wrinkled mass of paper inside the paper path, lift the Pinchwheels (opening the Rear Door)
and clear the obstruction.
●
Check that the OMAS Controller Card to PrintMech PCA cable is not damaged.
●
Check that the OMAS Controller Card to PrintMech PCA cable is correctly connected to the OMAS
Controller Card and the PrintMech PCA.
●
Perform the Media Drive Diagnostic (
Paper Drive test on page 84) to further troubleshoot the error
code.
SE 85:03
Cause: Problem finding the Drive Roller zero
Solution: Perform the Media Drive Diagnostic (
Paper Drive test on page 84) to further troubleshoot the
error code.
SE 86:01
Cause: Carriage servo shutdown; possible paper jam
Solution: Try the following.
●
Open the Window and check for any visible obstacles restricting the movement of the Carriage
Assembly. If there is a wrinkled mass of paper inside the paper path, lift the Pinchwheels (opening the
Rear Door) and clear the obstruction.
●
Perform the Scan-Axis Diagnostic (
Scan Axis test on page 83) to obtain further information on the
problem.
SE 86:11
Cause: Scan-Axis length requires too much force or energy
Solution: Try the following.
●
Check that cutter disengages correctly.
●
Lubricate Scan Axis.
●
Apply Preventive Maintenance Kit 1.
SE 87:01
Cause: Problem with the Scan Axis encoder sensor readings
Solution: Try the following.
66 Chapter 3 System error codes ENWW