Media used sections
●
Total media used in the printer.
●
Media used for each media type.
It is possible that the sum of the media used for each media type is lower that the total amount of
media used in the printer. This is because only the total media used in the printer is saved in the backup
EEROM which is located in the ISS PCA. When the Hard Disk Drive is replaced, the total media used per
media type is reset to zero (0), but the total media used is recovered from the backup EEROM.
Printhead section
The Printheads section displays the Printhead usage per slot.
●
Total Insertions: This is linked with the crane of the Ink Supply Tubes. When the Ink Supply Tubes are
replaced, the total insertions amount will be reset to zero (0).
Cartridge section
The Ink Cartridges section displays the ink usage per cartridge.
Preventive maintenance section
Once the value reaches 100%, the corresponding Preventive Maintenance Kit should be used. For further
details, see
Preventive maintenance on page 449.
Component usage
One cycle is counted when the Carriage makes one movement to the left of the printer and then returns to
the right.
To find the total of Monochrome ink consumed in cc use the the formula ^0.61. Example: For a value marked
as 11504, use the formula ^0.61 to convert it to cc=300cc (11504
0.61
=300).
Spittoon section
This section contains information on the different Spittoons located in the printer.
Event logs
This page contains the following information:
●
Last 20 System Error Codes (which prevented the printer from booting).
●
Last 20 System Warnings (which did not prevent the printer from booting, but which required the user
to acknowledge the problem).
ENWW How to interpret the Service Information Pages 21
To Next Page
Loading...