HP Designjet T7200

10. Check that all the Setup Printheads have some ink.
11. The front panel asks you to change the ink funnel and waste bottle, but you should ignore this request.
Continue the purge procedure, pressing OK to advance through the procedure, but without changing any
parts.
12. At the end of the procedure, the printer aligns the Printheads.
Reset Life Counters
The purpose of this Service Utility is to reset the internal life counters. There are two submenus that allow
you to:
●
Reset all the counters related to a Preventive Maintenance Kit (PMK).
●
Reset only the counters related to a specific replaced part.
NOTE: Always reset the life counter of a corresponding part only after replacing it.
Perform the Reset Life Counters utility as follows:
1. In the Service Utilities submenu, scroll to Reset life counters and press OK.
2. You will be given an option either to reset the life counter for all the parts related to a Preventive
Maintenance Kit (PMK) or to reset the life counter for a particular part only.
a. If you select to reset the life counter for all the parts related to a Preventive Maintenance Kit
(PMK), you will be given an option to reset the life counter of:
●
Preventive Maintenance Kit 1 (PMK1)
●
Preventive Maintenance Kit 2 (PMK2)
b. If you select to reset the life counter for a particular part, you will be given an option to reset the
life counter of the:
●
Carriage ME
●
Tubes and Trailing Cable
●
Scan Motor
●
Left Spittoon
●
Drop Detector
ENWW Service utilities 103