11. Remove two T-20 screws (Type A) that secure the Scan-Axis Motor.
NOTE: Make sure you hold the Scan-Axis Motor securely when removing the screws.
12. Remove the Scan-Axis Motor from the printer.
NOTE: After installing the new Scan-Axis Motor, make sure you perform the following Service Utility:
●
Reset scan motor life counter
Reset Life Counters on page 103.
Media-Axis Motor
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Left Cover See Cover, Left on page 215.
2. Remove the PW Cover
See PW Cover on page 331.
3. Remove the Left Connector Cover
See Connector Cover, Left on page 225.
ENWW Disassembly order 313
To Next Page
Loading...