3. The Carriage moves to the Cutter replacement position and the following message is displayed on the
front panel. After a few seconds the printer will begin to shut down.
4. Before replacing the Cutter, make sure that you turn the printer off at the rear switch.
Enable/Disable Firewall
The purpose of this Service Utility is to enable or disable the firewall of the printer.
Perform the Enable/Disable Firewall utility as follows:
1. In the Service Utilities submenu, scroll to Enable/Disable Firewall and press OK.
2. The printer checks whether the firewall is enabled or disabled.
3. When the following message appears on the front panel, you must select whether you would like to
enable or disable the firewall. Use the Up and Down keys to make your selection and press the OK key.
4. The system upgrades the internal memory to reflect the chosen selection.
5. If the utility exits correctly, OK will be displayed on the Front Panel.
Disk Wipe DoD 5330.22’M
The purpose of this Service Utility is to securely erase data on the Hard Disk according to the directive DoD
5220.22-M.
The printer's hard disk is used as a temporary storage area for print jobs. The Secure Disk Erase facility can
completely erase your information from the hard disk to protect it from unauthorized access.
Secure Disk Erase provides three different levels of security:
●
Insecure Mode: All pointers to the information are erased. The information itself remains on the hard
disk until the disk space it occupies is needed for other purposes, and it is then overwritten. While it
remains on the disk, it is difficult for most people to access, but may be accessed using software
designed for the purpose. This is the normal method in which files are erased on most computer
106 Chapter 5 Service tests and utilities ENWW
To Next Page
Loading...