SE 39.2:01.2
Cause: Unable to load roll 3 from standby/parking position; roll mispositioned
Solution: Roll 3 has been unloaded. Reload it and check that the paper is correctly aligned with the hubs.
SE 39.1:01.3
Cause: Unable to load roll 1 from standby/parking position; paper edges were not found
Solution: Roll 1 has been unloaded. Reload it.
SE 39.2:01.3
Cause: Unable to load roll 2 from standby/parking position; paper edges were not found
Solution: Roll 2 has been unloaded. Reload it.
SE 39.2:01.3
Cause: Unable to load roll 3 from standby/parking position; paper edges were not found
Solution: Roll 3 has been unloaded. Reload it.
SE 40:03
Cause: Smart Roll-loading System Motor shutdown
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Open the Smart Roll-loading System and check for any visible obstacles restricting its movement.
●
Replace the Smart Roll-loading System Gear and Motor
Smart Roll-loading System Gear
on page 251 and Smart Roll-loading System Motor on page 250.
SE 41:03
Cause: Paper motor electrical current limit
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Open the Window and check for any visible obstacles restricting the movement of the Drive Roller. If
there is a wrinkled mass of paper inside the paper path, lift the Pinchwheels (opening the Rear Door)
and clear the obstruction.
●
Replace the Media-Axis Motor
Media-Axis Motor on page 313.
SE 42:03
Cause: Scan-Axis motor electrical current limit
Solution: Try the following.
56 Chapter 3 System error codes ENWW
To Next Page
Loading...