HP Designjet T7200 - SE 01.3:10; SE 02.1:10; SE 03:10; SE 05:10

SE 01.3:10
Cause: ISS Bottom PCA communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Replace the Ink Supply Tubes and Trailing Cable.
NOTE: If the Ink Supply Tubes are to be replaced, the Ink Cartridges need to be checked beforehand to
see if they are capable of purging the new tubes. If they are not, new Ink Cartridges must also be sent
with the parts to be replaced. To check the Ink Cartridges, see
Check ink supplies on page 90.
SE 02.1:10
Cause: Carriage PCA communication failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Check that the Trailing Cable is not damaged.
●
Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and Main PCA.
●
Replace the Carriage PCA
Carriage PCA on page 277.
SE 03:10
Cause: Power distribution failure
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
If the Power Supply Unit's blue LED is on, replace the PrintMech PCA
PrintMech PCA on page 371. If
not, replace the Power Supply Unit
Power Supply Unit (PSU) on page 366.
SE 05:10
Cause: Formatter communication failure with ISS
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Check that the Formatter to PrintMech PCA cable is correctly connected.
●
If the printer is a Rev A, replace the Formatter
Formatter on page 360.
●
If the printer is a Rev B, replace the Formatter and the Hard Disk Drive
Hard Disk Drive (HDD)
on page 363.
SE 05.1:10
Cause: Formatter CPU fan stopped or burnt
42 Chapter 3 System error codes ENWW