Power
amber
LED
Power
blue
LED
Power
green
LED
Formatter I
LED
Formatter II
LED
Formatter
III LED
Front
panel
status
Problem and recommendations
Off On Off On On Off Off There is a communication failure with the
Main PCA.
1. Reseat the Main PCA.
2. Replace the Main PCA.
Off On Off On On Flashing Off There is an initialization failure in the
Formatter. Replace the Formatter.
Off On Off On On On Off There is an initialization failure in the
Front Panel.
1. Reseat the Front Panel cable.
2. Replace the Front Panel.
If the front panel turns on and then stops
If the power-up process stops while the front panel is displaying a number, respond as follows.
1. If the printer's Power-Up process stops when the front panel is displaying the number 17, this indicates
that there is a problem with the file system on the printer's Hard Disk Drive, so the printer is checking
the whole file system and making any necessary corrections. This problem can arise when there has
been a power cut while the printer was switched On, or if there is a physical problem with the Hard Disk
Drive.
Checking the whole file system normally takes about half an hour (but could take much longer). There is
nothing that can be done to speed up the file checking process. If you turn Off the printer during the
checking process, the file system check will restart whenever you turn it On again
If you experience this problem repeatedly when there has been no power cut, then this could mean that
the Hard Disk Drive is faulty. In this case, replace the Hard Disk Drive
See Hard Disk Drive (HDD)
on page 363.
2. If the printer's start-up process stops when the front panel is displaying any other number between 1
and 30, then try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the printer continues to stop during the power-up process, replace the Hard Disk Drive
See
Hard Disk Drive (HDD) on page 363.
How to interpret the Service Information Pages
The Service Information Pages contain the following information:
●
Current Configuration
●
Current Information
●
Usage Information
●
Event Logs
●
Calibration Status
ENWW If the front panel turns on and then stops 17
To Next Page
Loading...