HP Designjet T7200

OK to...), press Cancel and remove the USB Device. This means the Hard Disk Drive accessory is faulty
and should be replaced. See Formatter.
●
If nothing appears on the front panel reacting to the USB device just connected, the Formatter is faulty
and should be replaced. See Formatter.
SE 71:03
Cause: Out of memory failure
Solution: Try the following.
●
Turn off the printer using the switch at the rear, and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the problem persists, resend the job with one or more of the following options:
◦
Decrease resolution to 300 dpi.
◦
Select Economode print mode.
◦
Select Send Job As Bitmap, to have the main processing of the print job done by the computer
rather than the printer.
SE 71:08
Cause: Insufficient display list
Solution: Resend the job with one or more of the following options: decrease resolution to 300 dpi, select
Economode print mode, select Send Job As Bitmap to have the main processing of the print job done by the
computer rather than the printer.
SE 74:01
Cause: Error uploading firmware update file
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Resend the firmware update file to the printer.
SE 75.21:10
Cause: Total printer ink consumption reached upper limit
Solution: This is a continuable system error. The customer may continue to print normally but may
encounter print-quality issues or ink buildups in the Service Station. To avoid these problems, it’s best to
apply Preventive Maintenance Kit #2.
SE 76:03
Cause: Hard Disk Drive out of space
Solution: Try the following.
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power cord
and turn on the printer.
●
Resend the file to the printer.
64 Chapter 3 System error codes ENWW